ATOP Fine Gold Vacuum Coating Machine On The Surface Of ABS/PC Plastic Products

(1). Power supply: five-wire three-phase, 380V±5%, 50Hz, with ground resistance<5Ω

(2). Compressed air : 0.5～0.7Mpa

(3). Cooling water can use city tap water, deionized water is best. Temperature of cooling water should

less than 25℃. Water pressure should be 0.2Mpa to 0.4Mpa. And the water resource should have the

ability to add new water in rate more than one hundred liter per minute.

(4). Environmental condition: Floor, ceiling and walls should be clean. Indoor air should be clean, dry and

no-dust. No flammable, explosive and corrosive gas indoors.

(5). Coating air: Ar2 high purity(≥99.99%)

When the evaporation materials such as aluminum wire installed in high-resistance materials, Joule heat

generated by the current under high temperature, evaporation material instantly evaporated vapor China

to migrate to the surface of the substrate, the deposition film.
 

It is equipped with a low-temperature auxiliary ion beam source
 

1. It has a large area of plasma discharge, high ionization effects, improve bond strength, adhesion

particularly strong.

2. The ion are distributed evenly, which greatly improves the stability and uniformity of the film.

3. The ionization effect is good, coated plastic, resin, acrylic and other products can be easily coated with

the film.

4. Give full play to the ionization effect, plastics do not spray primer, directly on the plastic coating.

1. Variety of structure : vertical type ; horizontal type ; single door type ; double-door type.

2. Equipped with 1-2 sets new model evaporation electrode, easy installation and discharge, convenient

maintenance. Work rack flexible and reliable by public rotation of gear transmission structure.

3. Reasonable configuration for the vacuum system. High pumping speed, high efficiency, energy saving,

full automatic process controller can be simple, reliable, beautiful.